Buy Voopoo Drag Nano 2 Pod Cartridge 3pc/Pack in Dubai, UAE

Buy Voopoo Drag Nano 2 Pod Cartridge 3pc/Pack in Dubai, Abu Dhabi UAE

The Voopoo Drag Nano 2 Pod has a 2.0 mL vape juice capacity and comes in a set of three. The black mouthpiece may be removed to top fill the pod, which also has a magnetic connection to the Nano 2 Device. There are two accessible pod sizes: 0.8 and 1.2 ohms, with the 0.8-ohm resistance providing a little warmer vape.

Cartridge for VooPoo Drag Nano 2 Pods

Leaks in the Drag Nano 2 Pod?

Nothing noteworthy. Occasionally, I have noticed the tiniest bit of e-liquid under the pod. but honestly, it hasn’t been enough to bother about cleaning up. Even the additional heat from being in my pocket hasn’t led to a leak. even though I frequently carry this around in the front pocket of my trousers all day. This tiny vaping apparatus is really clean.

Devices that work well:

Pod Port for Voopoo DRAG Nano 2

The pod port is a rounded rectangle with two tiny holes in the middle of a plastic. plate located directly at the bottom. The draw activation sensor is positioned through these tiny holes. There are connecting ports on either side of that.

Apart from the two indents on the lengths of the port walls, there isn’t much anything noteworthy. To hold the pod in place, these indents correspond to a lip on either side. However, I can’t remember how deep the original port was. it’s clear that the new pod port is much shallower because of the pod change.

Voopoo drag nano 2 replacement pods at the best price Setting parameters

• Holds two milliliters
• Composition: PCTG
• Coil resistance: 0.8Ω and 1.2Ω
• Dimensions: 72 44 14.2 mm
• Quantity: 3 pieces per pack

DRAG Nano 2 Cartridge by Voopoo

The pods’ bodies are somewhat conventional. The portion of the pod that enters the port is thinner and blacker than the remaining portion. You can readily see how much liquid is in the pod because the majority of the e-liquid is above the port. where the transparent portion is located. Since the fill port is located beneath the mouthpiece, I haven’t addressed it yet. Pulling or tilting off the black mouthpiece is how you remove it. This exposes the silicone bung that runs the entire length of the pod’s top. The filling hole is visible when it is lifted to one side.

Here are a few problems.

First off, I don’t think it’s a good idea to have the filling port under the mouthpiece in the long run. But because the pods are changeable, I don’t really care. That might not be a big deal if you take precautions. But it does increase the possibility of the chimney becoming “flooded,”. Particularly if the pod is overfilled.